Home > Roller Skates > Roll Line Skates >

Roll-line Mounting Hardware
Roll line Mounting hardware , fixing kit
Roll-line Mounting Hardware


 
Roll-Line Mounting Hardware
Our Price: $10.00


Product Code: ROLLLINEACCMOUNTHARDWARE
Qty:

Description
 
Roll-Line Mounting Hardware
Fixing Kit
All the hardware needed to properly
mount your Roll line plate to most of skate boots


Features

The Roll-Line Mounting Hardware Kit is the little bag with the Hardware to properly mount your Roll-Line Skates to most any Skating Boot.

The Roll-Line Kit Includes:


1- Four (4) Long Mounting Bolts for the Heels
2- Eight (8) Short Mounting Bolts for the Ball of the Boots
3- Twelve (12) Flat Washers
4- Twelve (12) Nuts that utilize a 7mm Wrench

(This same kit can be used to mount ATLAS, Snyder, or most other Frames (including Inline Frames) to most Skating Boots.)


The Mounting Hardware Kit (Fixing Kit)should be used with an 11/64" Drill Bit and a Countersink when drilling your Skating Boots.

On Today's Skating Boots, it is strongly recommended to NOT use the Snyder Boot marking tool, as this will in most cases move the Toe of the Frame too far to the outside of the boot.

It is strongly recommended to use all Four (4) of the Mounting Hardware Kit (Fixing Kit) Short Bolts, Washers, and Nuts and the EDEA Power Wedges in the Ball area of both Skating Boots.

Be sure to tighten all of the Mounting Nuts and even consider using a touch of Blue, Removable Lock Tite.


Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

Roller Skates > Roll Line Skates
Roller Skates > Roll Line Skates > Roll Line Accessories